Magnum 120 and 120/240VAC E-Panels

The 120AC Magnum E-Panels are available in steel
or aluminum enclosures. The 120/240VAC
E-Panels are available in steel only. The Magnum
inverter/chargers are rapidly gaining acceptance in
the industry due to ease of operation, reliability and
high performance. The Magnum E-Panel has all the

required components to make installation a breeze.

Features include:
• AC input bus
• Neutral bus
• AC output bus
• PV+ input bus
• 500 amp shunt
• Battery plus and minus bus
• Inverter battery breaker and cables
• Din rails for AC or DC breakers
• Pre-wired AC output/AC bypass switch
   including inverter AC wires

Swing the door open for unobstructed access to the
wiring and disconnects.

OutBack E-Panel

This series of E-Panels has several models:

• Narrow 9.5” wide – available in
  aluminum or steel

• Stretched 14.5” wide
  • Available in aluminum or steel
  • Accommodates OutBack Surge
    Arrestor

• ‘Plus’ Stretched 14.5” wide
  • Aluminum enclosure
  • Incorporates charge controller
    mounting on door with the inverter for
    a compact installation

• ‘Lite’ 9.5” -or- 14.5” wide
  • Designed for generic inverters such
    as the Xantrex DR series
  • Inverters mount to the left or right of
    the E-Panel chassis – not on the door
   

There is an E-Panel for every OutBack off
grid or grid tie inverter – sealed or vented -
12, 24 and 48 volt, 120VAC 60Hz and
230VAC 50Hz. The feature list replicates
the Magnum feature list. MidNite E-Panels
are available in right or left hinge door and
breaker mounting.

Please Contact Us for current competitive pricing on any size E-Panel.

ADDITIONAL FEATURES

• Small size compared to existing disconnect and over current solutions
• Pre-wired to save time, money and complexity. All field wiring connections clearly labeled
• White powder coated aluminum or standard gray powder coated steel
• Three slots for ¾” wide panel mount breakers like the MNEDC80
• Easily expands to accommodate additional inverters
• Six slots for ½” wide din rail mount breakers like the MNEPV63
• Pre-wired 50 amp 277VAC rated Inverter AC bypass switch
• Pre- wired 50 amp 277VAC rated AC Input disconnect
• Bus bars for Battery Plus, Battery Minus, ground, PV+, PV-,
AC hot in, AC hot out, Neutral
• Mounting hardware for Inverter and charge controller
• Mounting brackets for hanging E-Panel on wall
• ETL listed to UL and Canadian standards
• Standard Left hand hinged door to mount inverter - Right
hand optional
• Knockouts for AC and DC conduits
• Charge control brackets (CCB) & 1” close nipple
• Cut outs for one GFCI outlet
• DC Inverter Battery breaker 125A, 175A, or 250A
• Internal inverter cables